Model 75AT/85AT How to Use
Simple instructions and video link
Marc Steele
Last Update منذ عام واحد
How to use:
Assure that the stamp is mounted onto the end of the marker and the pin is holding it in place. Grasp the handle of the marker firmly with your wrist straight. Hold the marker against the surface you wish to mark at a 90°(square) angle to assure that all characters on the stamp are touching the surface. Press the marker down hard and quickly.
Lifting the marker off the surface will reset it. The internal anvil will make an audible “Click” sound to indicate that it has reset and is ready to fire again.
Use of the marker should leave a cleanly embedded character on the intended surface if used correctly, if the mark is too light or too heavy, refer to the pressure guide.
IMPORTANT POINT
The higher the air pressure used, the harder you must push to fire the marker.